smartctl 6.1 2013-03-16 r3800 [i686-w64-mingw32-win7-sp1] (sf-6.1-2) Copyright (C) 2002-13, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: SAMSUNG SpinPoint T166 Device Model: SAMSUNG HD160HJ Serial Number: S0D4J1KP203840 LU WWN Device Id: 5 0000f0 01b203840 Firmware Version: BF100-12 User Capacity: 160'041'885'696 bytes [160 GB] Sector Size: 512 bytes logical/physical Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS T13/1699-D revision 3b SATA Version is: SATA 2.5, 3.0 Gb/s Local Time is: Sat May 10 10:06:35 2014 WEDT SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Disabled APM feature is: Disabled Rd look-ahead is: Enabled Write cache is: Enabled ATA Security is: Disabled, frozen [SEC2] === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x02) Offline data collection activity was completed without error. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 2939) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 49) minutes. SCT capabilities: (0x003f) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-- 253 100 051 - 0 3 Spin_Up_Time POS--- 253 253 025 - 4224 4 Start_Stop_Count -O--CK 100 100 000 - 657 5 Reallocated_Sector_Ct PO--CK 253 253 010 - 0 7 Seek_Error_Rate POSR-- 253 253 051 - 0 8 Seek_Time_Performance P-S--K 253 253 015 - 0 9 Power_On_Hours -O--CK 100 100 000 - 10673 10 Spin_Retry_Count PO--CK 253 253 051 - 0 11 Calibration_Retry_Count -O--C- 253 253 000 - 0 12 Power_Cycle_Count -O--CK 100 100 000 - 496 184 End-to-End_Error -O--CK 100 100 000 - 128 187 Reported_Uncorrect -O--CK 253 253 000 - 0 188 Command_Timeout -O--CK 253 253 000 - 0 190 Airflow_Temperature_Cel -O---K 157 115 000 - 27 194 Temperature_Celsius -O---K 151 112 000 - 29 195 Hardware_ECC_Recovered -O-RC- 253 100 000 - 255 196 Reallocated_Event_Count -O--CK 253 253 000 - 0 197 Total_Pending_Sectors -O--C- 253 253 000 - 0 198 Offline_Uncorrectable ----CK 253 253 000 - 0 199 UDMA_CRC_Error_Count -OSRCK 200 200 000 - 0 200 Multi_Zone_Error_Rate -O-R-- 253 099 000 - 0 201 Soft_Read_Error_Rate -O-R-- 253 100 000 - 0 202 Data_Address_Mark_Errs -O--CK 253 253 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 2 Comprehensive SMART error log 0x03 GPL R/O 2 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (2 sectors) No Errors Logged SMART Extended Self-test Log (GP Log 0x07) not supported SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Extended offline Completed without error 00% 10671 - # 2 Extended offline Completed without error 00% 6595 - # 3 Extended offline Completed without error 00% 3689 - # 4 Short offline Completed without error 00% 3686 - SMART Selective self-test log data structure revision number 0 Note: revision number not 1 implies that no selective self-test has ever been run SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 2 SCT Version (vendor specific): 256 (0x0100) SCT Support Level: 1 Device State: Active (0) Current Temperature: 29 Celsius Power Cycle Max Temperature: 28 Celsius Lifetime Max Temperature: 42 Celsius SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 10/55 Celsius Min/Max Temperature Limit: 5/60 Celsius Temperature History Size (Index): 128 (97) Index Estimated Time Temperature Celsius 98 2014-05-10 07:59 31 ************ ... ..( 9 skipped). .. ************ 108 2014-05-10 08:09 31 ************ 109 2014-05-10 08:10 30 *********** 110 2014-05-10 08:11 31 ************ ... ..( 13 skipped). .. ************ 124 2014-05-10 08:25 31 ************ 125 2014-05-10 08:26 30 *********** 126 2014-05-10 08:27 31 ************ 127 2014-05-10 08:28 31 ************ 0 2014-05-10 08:29 31 ************ 1 2014-05-10 08:30 30 *********** 2 2014-05-10 08:31 31 ************ ... ..( 4 skipped). .. ************ 7 2014-05-10 08:36 31 ************ 8 2014-05-10 08:37 30 *********** 9 2014-05-10 08:38 31 ************ ... ..( 9 skipped). .. ************ 19 2014-05-10 08:48 31 ************ 20 2014-05-10 08:49 30 *********** 21 2014-05-10 08:50 31 ************ 22 2014-05-10 08:51 30 *********** 23 2014-05-10 08:52 31 ************ 24 2014-05-10 08:53 31 ************ 25 2014-05-10 08:54 31 ************ 26 2014-05-10 08:55 30 *********** 27 2014-05-10 08:56 31 ************ 28 2014-05-10 08:57 30 *********** ... ..( 2 skipped). .. *********** 31 2014-05-10 09:00 30 *********** 32 2014-05-10 09:01 31 ************ 33 2014-05-10 09:02 30 *********** ... ..( 27 skipped). .. *********** 61 2014-05-10 09:30 30 *********** 62 2014-05-10 09:31 32 ************* ... ..( 2 skipped). .. ************* 65 2014-05-10 09:34 32 ************* 66 2014-05-10 09:35 31 ************ ... ..( 13 skipped). .. ************ 80 2014-05-10 09:49 31 ************ 81 2014-05-10 09:50 30 *********** ... ..( 3 skipped). .. *********** 85 2014-05-10 09:54 30 *********** 86 2014-05-10 09:55 31 ************ 87 2014-05-10 09:56 30 *********** ... ..( 2 skipped). .. *********** 90 2014-05-10 09:59 30 *********** 91 2014-05-10 10:00 ? - 92 2014-05-10 10:01 27 ******** 93 2014-05-10 10:02 27 ******** 94 2014-05-10 10:03 28 ********* ... ..( 2 skipped). .. ********* 97 2014-05-10 10:06 28 ********* SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP Log 0x04) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 0 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 1 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0010 2 0 R_ERR response for host-to-device data FIS, non-CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x0013 2 0 R_ERR response for host-to-device non-data FIS, non-CRC 0x8001 2 0 Vendor specific